Search results

Call the engineer that set them up. I would bet that he has notes of the setup just in case you needed to due some more work or to correct some errors. That would get you a great head start.

Hmmm???? Filter Caps??????

Since I hurt my back I went to a 1X12 enclosed(Earcandy Sov) cabinet, with my Boogie head. I wonder now why I didn't do it years ago

Totally retro colors. The "Harvest" colors in vinyl. Probably has orange shag carpet too...

That would be 2525....Cool song :)

I have always loved that look....

I'm glad I can't play as well as JP. Who would want all of that attention and fame and fortune. Now Back to my dreary fart smelling studio.......

The older Blackface and Silverfaced Fenders had one side fixed. No adjustment to that side. The thought at the time was you would adjust the Bias pot until you had minimal noise. The Bias pot would only be adjusting the voltage on one tube. There was no concern as to what voltage the tubes where...

Fenders are kinda fixed bias. I've been using one of these for a while now to check the bias of my tubes., works great. You do not want to leave it in the circuit very long but for setting/checking the bias is OK...

Close but the Boogie knobs go from 0 to 10.

The only thing powered in the tubes is the heater on standby. The plates where not getting any power. Still Not a good practice to continue. As far as how it will effect the life of your tubes would be hard to predict. Usually the plates go before the heaters, or I should say that is what we...

The open back 1X12 are usually less expensive and more plentiful. If it's a Thiele cabinet I'll trade you one of my open Back cabs. I've been looking for another Thiele.

I think Stokes is from NYC, you might try private messaging or emailing him.

I use a 60 watt Graphic EQ/Reverb Mark IIB Head that I converted from a combo. I still have the combo in an anvil. Compared to my buddies C+ volume is about the same but his lead channel is more articulate. Not that the IIB is a mutt either, the C+ just lays it out a little nicer. The clean...

My wife has 2 huge cats that love to hang out in my Studio, They love the height the speakers give them or something relating to that. They don't hang around long when those speakers get to thumping'. However my dog likes to lay at my feet while I'm playing, seems to enjoy the sounds...

I use a Radial Big Shot and a Ebtech. No more cheap Hummers. Quite as can be, even cranked.

may possibly be a cold solder joint, once it warms up it make a little bit better contact and then its OK. Call Mesa for sure.....

When tubes where first attached to the boards the heat would effect the board and cause troubles after a while. I have not heard of this type of PCB disintegration for quite a while. PCB's are commonly found in Soldano's/Diezels/Fuchs and many other "Boutique " high dollar amps. Personally I...

I looked but didn't reply. Thanks for taking the photo's I've really got bad GAS for a LSS or a 25:5 Express. I'm going to have to make the 5 hour drive to try them out. Photo's like these are very helpful. As far as the PCB's many other amp manufactures that offer less options use PCB's also...

Is the hiss affected by the treble tone pot? Does dialing treble or bright down make it go away, or reduce it? I know with my amps as the gain goes up the treble has to go down or the snakes start crawling out. A noise gate in the effects loop may eliminate the hiss also. Unfortunately when...