Search results

I just got a Mesa Single Rectifier v2. I bought it off eBay and just came in yesterday. It is in great shape, plugged it in and started in the clean channel and started to go through the different modes. When I got to channel 2 and switching between RAW, VINTAGE and MODERN there was really a big...

Check out or call the guys at EuroTubes. I just dropped a full set of JJ's in my Single Rec and I love it. I got the High Gain Pre's for V1,V2,V3 a normal JJ12AX7 for V4 and balance JJ12AX7 for V5 and 2-6V6 for power. It is AWESOME. It drops it down between 25-30watts and the you can get better...

I have a Single Rec. and lost the MIDI cable to the pedal. My question is this. It is a 5-pin MIDI. Will any MIDI 5-pin work (5-Pin Monster??) or does it have to be wired specifically to control the Mesa Foot Pedal? theDogger

OK good to know. I'll check the plate voltage again w/ the MESA 6l6GC's before installing the 6V6's and measure the BIAS again after w/ the JJ6V6's. I'll post those numbers and see if I can't get a decent recording of the JJ6V6's. Also do you know of any good posts or threads that have info...

Ok I measured my plate voltage and it was 432 volts and the Mesa 6L6's were biased @ 29mA. Pretty cold. I am in the process of researching a BIAS Adjust. (Anyway All the Mesa Rectifiers that I have seen are way cold. My buddies Dual Rec. is running @ 26mA.) I would like to be able to BIAS the...

Anyone running 6V6 tubes in their Single Rectifier and how do you like as opposed to the 6L6GC? Also how exactly does the 6V6 drop the wattage down to around 25-30 watts? theDogger :mrgreen:

Just reading through the thread and have a few questions? 1-What are you BIAS'ing the tubes at? E34L @ 25watts dissipation 6L6GC @ 25watts dissipation What are you getting for Plate Voltage at the 3rd pin? I noticed a lot of cold settings. Isn't the formula for BIAS'ing as follows 70% times...

I have a few question about the Single and Dual Rec. I am actively looking right now... Are some dates better than others? What are common issues? What are some question that should be asked...What should I avoid? Also I have a custom 4x12 cab that I made and is either 1-16 ohm mono or 2-8 Ohm...