Hi everyone,
I am new to Mesa Boogie and I have a question I am hoping you guys can help with. I recently bought a Mark V and paired it with a Rectifier 2x12. Everything was working great until I decided to build a new pedal board and now I am having issues. I have interference on all channels though that isn't as concerning as if I run anything through the FX loop. If I do I get very little volume and a lot of distortion even in Channel 1. Before I put the pedals on the new board and had them running the same configuration everything was fine and I am not sure what I did wrong. Loop Send level is in the middle. If I bypass the loop all I get is a bit of interference but it sounds great.
I have a pic of the set up below.
I am running the guitar > Wah > NS-2 Input > NS-2 Send > CS-3 > TS9 > Cyber Demon > NS-2 Return> NS-2 Output > Mark V Input. This is working though I have more interference than before, I may need to move the power supplies and cables.
The FX loop is driving me nuts. I am running FX Send > Drop > DD-7 > CE-3 > MT-2 > Return. Again, very little volume and tons of distortion whether the pedals are on or off.
Any suggestions?
Thanks!
https://imgur.com/45v0lSh
I am new to Mesa Boogie and I have a question I am hoping you guys can help with. I recently bought a Mark V and paired it with a Rectifier 2x12. Everything was working great until I decided to build a new pedal board and now I am having issues. I have interference on all channels though that isn't as concerning as if I run anything through the FX loop. If I do I get very little volume and a lot of distortion even in Channel 1. Before I put the pedals on the new board and had them running the same configuration everything was fine and I am not sure what I did wrong. Loop Send level is in the middle. If I bypass the loop all I get is a bit of interference but it sounds great.
I have a pic of the set up below.
I am running the guitar > Wah > NS-2 Input > NS-2 Send > CS-3 > TS9 > Cyber Demon > NS-2 Return> NS-2 Output > Mark V Input. This is working though I have more interference than before, I may need to move the power supplies and cables.
The FX loop is driving me nuts. I am running FX Send > Drop > DD-7 > CE-3 > MT-2 > Return. Again, very little volume and tons of distortion whether the pedals are on or off.
Any suggestions?
Thanks!
https://imgur.com/45v0lSh