Pop when switching channels

[kevin_12345us]

I get a loud pop when switching channels. The from & to channel are configured about the same (power, volume, etc.)

I know the manual says to expect this, but it is so loud you could never switch live during a performance.

Anyone else experience this?

Thanks

 

[MesaManBoogie]

I get a loud pop when switching channels. The from & to channel are configured about the same (power, volume, etc.)

I know the manual says to expect this, but it is so loud you could never switch live during a performance.

Anyone else experience this?

Thanks

I get that if I have channel one set to 10 watts and the other two to 45 or 90 or viceversa
I set mine to where all the channels are the same wattage or close.

 

[kevin_12345us]

I have all my channels set to the same 10w or 45w.

 

[ericfrape]

I have a LSS and this happens when switching between channels when the power setting is set different - mainly between 30W and 5W mode. I think it has something to do with the different rectifier setups. On the LSS the 30W uses a ss rectifier and a tube rectifier on the 5W and 10W. I think I read the Mark V uses different rectifier setups as well depending on power settings but you can actually customize the set up on the Mark V. Check it out in the manual - if you align how the rectifier is set up between channels you may have some luck with getting rid of or reducing the pop.

 

[MusicManJP6]

I have all my channels set to the same 10w or 45w.

+1