talltxguy
Well-known member
Hey ya all,
I'm gonna run my Studio Preamp into the 50/50 into a 1/12 Roadster cab. Was reading the 50/50 manual, and it said, "If you wish to use only one of its channels, it is necessary to: 1) Make sure a speaker (or load resistor) remains connected to a speaker jack on both channels, including the unused one."
I called the Mesa dudes, and they said to just keep the level at 0 although he didn't sound 100%. So is that it? Or do I need some special plug to put into the other speaker jack?
Thanks again!
Scott in TX
I'm gonna run my Studio Preamp into the 50/50 into a 1/12 Roadster cab. Was reading the 50/50 manual, and it said, "If you wish to use only one of its channels, it is necessary to: 1) Make sure a speaker (or load resistor) remains connected to a speaker jack on both channels, including the unused one."
I called the Mesa dudes, and they said to just keep the level at 0 although he didn't sound 100%. So is that it? Or do I need some special plug to put into the other speaker jack?
Thanks again!
Scott in TX