I need help getting rid of some bad noise I'm getting with my new setup. I added a GSP1101 to my Triaxis because it gives me pre and post gain effects. Mostly I like it because I can use reverbs, chorus and delay post preamp and also have compression for cleans, overdive, wah and pitch/detune before the Triaxis. Everything was ok until I bought a new SSS Strat with fat 50s last week and I can't get rid of the hissing and hum, its noisy with any amount of gain, with or without compression. The strat is brand new, I've tried different cables too. I notice that the noise dissipates a lot when I'm in position 2 and 4. In position 1, 3 and 5 the noises are almost as loud as the notes I'm hitting, definitely unusable. I've played with the noise gate, I even hooked up a Boss NS2 between my guitar and the GSP as a 2nd gate but the noise problem persists. It's fairly quiet when I'm not playing. I've tried ground lifting the Triaxis and GSP, tried Triaxis loops send and regular output, tried +4/-10 and about every level combination imaginable. I think my Triaxis just hates this unit in front of it. I had heard somewhere about cutting the ground off of cables in my chain but before I go hacking up my gear I wanted to see what the gurus on this forum had to say. I won't part with my Triaxis, am open to buying 2 different rack mount effects units and selling the GSP if there is one out there that my Triaxis can get along with in front of it.
My setup is this: Guitar into GSP1101 front input, GSP1101 loop send into Triaxis input, Triaxis main output into GSP1101 loop return (mono), GSP1101 line out (mono) into Mesa Boogie 20/20 then out to a Carvin Legacy 2x12 cab with V30s. All gear is plugged into a Pyle power conditioner in the same rack and I keep the power cables away from line cables or they cross paths but never run parallel.
Thanks for any advice or possible solutions anyone can offer!
My setup is this: Guitar into GSP1101 front input, GSP1101 loop send into Triaxis input, Triaxis main output into GSP1101 loop return (mono), GSP1101 line out (mono) into Mesa Boogie 20/20 then out to a Carvin Legacy 2x12 cab with V30s. All gear is plugged into a Pyle power conditioner in the same rack and I keep the power cables away from line cables or they cross paths but never run parallel.
Thanks for any advice or possible solutions anyone can offer!