Anyone have a hard time matching up the clean channel to be the same or less volume than the distorted? i have it great at band practice.. but for some reason when i play shows.. the clean channel just always cuts through as a lot louder.. even when i crank the master volume on my channel 4 or 3. :-\ could i need a compressor or something? (have one on my g system)
Roadster clean channel
- Thread starter Indigo
- Start date
Help Support The Boogie Board:
TheBlackman
Well-known member
I seem to have the opposite problem, getting my clean loud enough! how high are your gain settings and where are your mids at on ch3 & 4?
MusicManJP6
Well-known member
TheBlackman said:
This seems to be the more common problem...
hm. on my channel 4 of the roadster.. i have my mids at 10 oclock.. gain at 11 oclock. master volume is at 3 oclock.
clean channel master volume is seriously at like 9 oclock. doesnt seem louder at band practice.. but in a show environment was very loud! and when id switch back to distortion it just seemed low.
clean channel master volume is seriously at like 9 oclock. doesnt seem louder at band practice.. but in a show environment was very loud! and when id switch back to distortion it just seemed low.
jdurso
Well-known member
Indigo said:
What are your eq settings, your tube settings, wattage settings and voicings on each channel? Also are you using spongy or bold power?
TheBlackman
Well-known member
is there anthing it the loop that could affect it? is the loop active on all channels when you switch to each one?
jdurso
Well-known member
Indigo said:
I meant for all your channels.... the mismatch in volume maybe due to the mods or power options your using.
