bargainbob
New member
- Joined
- Mar 29, 2008
- Messages
- 4
- Reaction score
- 0
I figured it would be easier to post than search so here goes.
Rectoverb series 2 head with serial loop conversion.
Freshly retubed preamp tubes except the loop/ reverb driver which sounded good so i left it in.
Power tubes are EL-34's about six months old and not driven hard.
All mesa tubes.
I just put in the new tubes and everything sounded great. I had it on the clean setting channel 1 and it sounded great.
Switching between channels worked fine.
After about 15 minutes I switched to the pushed setting and the whole channel blinked out. All I can hear is the reverb.
The red channel sound great and still works fine.
Any advice or suggestion would be appreciated.
Thanks.
Rectoverb series 2 head with serial loop conversion.
Freshly retubed preamp tubes except the loop/ reverb driver which sounded good so i left it in.
Power tubes are EL-34's about six months old and not driven hard.
All mesa tubes.
I just put in the new tubes and everything sounded great. I had it on the clean setting channel 1 and it sounded great.
Switching between channels worked fine.
After about 15 minutes I switched to the pushed setting and the whole channel blinked out. All I can hear is the reverb.
The red channel sound great and still works fine.
Any advice or suggestion would be appreciated.
Thanks.