CoG said:I just use a cheapass ART SP4x4. Works fine.
I have to disagree with a couple of points here. In my rig I use both the Furman Power Factor Pro to filter and stabilize the current and the Furman AR-1215 to stabilize the voltage. In the summer the power in my house is all over the map, varying from 90v to 126v. It's also very noisey, electric motors,tools, and other appliances all send noise through the line that will negatively affect any high gain amp. Using the the PF PRO stabilized and cleaned the current, providing a current reserve that DID improve the sound of the amp. But immediately the LED readout on the PF Pro made me aware that the voltage in my house varied widely so I then added the AR-1215 to remedy that problem so as not to chance damaging any of the digital stuff (which seems to be espicially sensitive to voltage variances). I also have the problem of having a 390 ft tall radio tower 1-1/2 blocks from my house that pushes out 150,000 watts of moldy oldies that bleeds through everything electrical. The two Furman units have eliminated that headache completely. So I would suggest that anyone should get the best power conditioning they can afford because IMO it makes no sense to drop a bunch of cash on a nice rig efx etc., and then feed it dirty power.Gregwor said:Tonally with my gear, I hear no difference. I like having the Furman AR-1215 voltage regulator for tour though because I've personally encountered shows where the power available was only 90VAC. Long story short, if you can afford a regulator, get one. But if you aren't touring and just playing at home / recording, don't waste your money.. buy the cheapest one you can get.. even if it's just a power bar.
Enter your email address to join: