My DR pilot lamp won't light up

[junior]

So, my pilot lamp doesn't light up anymore. The amp works just fine. I tried to replace the lamp, but I can't remove it. My fingers can't reach it properly.
Anyone knows how to remove the lamp?
Sorry for the bad english. Thanks!

 

[mikey383]

Push it in with a finger, and turn it to the left while keeping pressure on it. It should pop out and you can grab it then. It's not a screw-in bulb, it's one that's spring loaded.

 

[junior]

Thanks a lot man!!!
I would never know that!!

 

[junior]

Is this a good replacement for my DR?

http://www.tubeampparts.com/Merchant2/merchant.mv?Screen=PROD&Product_Code=PLB&Category_Code=PL&Product_Count=10

The specs are right? 6V, 0.15A

Thanks again.

 

[Boogiebabies]

That's the one. The old #47.

 

[flatliners77]

thanks , i had the same prob

 

[chemten]

thanks. very helpful for me too.

 

[phyrexia]

Your english is better than a lot of the natives around here

 

[junior]

Thanks lol

I just bought a new lamp to replace the old one.
Philips 6.3V 0.15A
It's working fine!

 

[strange[ling]]

Your english is better than a lot of the natives around here

exactly what i was about to say