Hello! I'm looking for some advice on what's up with my 2:100 power amp.
I hooked it up today after about a month of not being used, and when I switched it out of standby it's still sitting at the same volume I last used it at (which is pretty loud!), even though I have the volume knobs completely turned down. Any ideas on what would cause this? I've check all my connections, tried different guitars, cables, and even double checked to make sure I wasn't mistaking the presence control for volume. I can only turn the volume louder from where it is...the tubes are all glowing consistently - I'm not a tech, so I don't have a clue where to start!
Any suggestions?
Thanks!!
Neil
I hooked it up today after about a month of not being used, and when I switched it out of standby it's still sitting at the same volume I last used it at (which is pretty loud!), even though I have the volume knobs completely turned down. Any ideas on what would cause this? I've check all my connections, tried different guitars, cables, and even double checked to make sure I wasn't mistaking the presence control for volume. I can only turn the volume louder from where it is...the tubes are all glowing consistently - I'm not a tech, so I don't have a clue where to start!
Any suggestions?
Thanks!!
Neil