how to remove the mesa logo on a 4x12 cab

[Johnnybyall]

my mesa faceplate/logo has been bent over the years and i was trying to take it off the straighten it out. I removed the 2 screws on each side and it still wont pull off. Is the logo glued on too or are there screws coming from the backside? Trying to see how anyone has gotten theirs off, thanks

 

[MesaENGR412]

It's just a little seal that is on it. Take a knife and slide the sharp blade side underneath the edge, and do a prying motion. Be careful not to stab the blade through the clothe. It will pop off. The name plate has a soft backing that I guess adheres itself to the grille, but it is not glued.

-AJH