Search results

I did too, the place I was dealing with had their heads up their asses :x

just watch the levels if you use anything in the loop. Have you been here yet? http://www.tubefreak.com/triaxis.htm

I'm still waiting on my delivery :roll: I would caution people to not go too far from the TL072, with limited knowledge of the circuit, things may get a little "scary" :shock:

No problem, I hope they are a good starting point, lots of variables come into play, but you can see a trend with many of the patches, enjoy. Robert

http://www.triaxis-page.com/shared/pdf/artistab.pdf

http://www.futurlec.com/index.shtml Op Amp: OPA2134PA 8 pin socket: ICS8 I'll post back when I actually receive this stuff just to make sure everything is on the up and up, I placed the order 3weeks ago:?

I'm still waiting for my BB to show up in the mail to do this mod. I'll take pics of the process for the peps on here.

Not to shine a sour light on Pauly, but did you happen to listen to his clip of his engl that he recently bought? I don't think you guys have the same tonal quest going on.

Guitar>TriAxis(record out to tuner)>Gmajor>BBE(I would consider losing this if I were you,but I put it in there anyways)>power amp>speakers. :wink:

Did he run the adapter into the TriAxis?

Did he run the adapter into the TriAxis/

No, I've just been checking with my multimeter.

I've done a bit of that and couldn't find anything out of spec.

Yeah, I tried that and it's the same. The problem is definitely after the loop, I just can't narrow down the problem to a specific part failure :x

Awhile back I went to play through my rig and 20 seconds after firing it up the volume faded out. The first thing I did was change out all the tubes with ones that I knew were o.k. no change. I opened it up took a look around nothing fried. Then I checked to see if I was getting signal from the...

remove the top, you will need to remove the pcb on the left(front facing you), to remove this pcb disconnect the three wiring harnesses and then, with the use of some needle nose pliers compress the tabs of the white board anchors and with slight upward pressure lift the board up and out. Now...

I don't know the weight but it's definitely more now. New pics I just got the sus 4 rack and I'll be experimenting with the furman parametric. I'm planning to pick up a GCX switcher and an ac power supply to power all the units that use wall warts then I'll re-wire the entire rig again, this...

http://www.partsexpress.com/pe/pshowdetl.cfm?&Partnumber=092-028 all connections are Neutrik :wink:

Thanks, I wish I could say that I know enough to give a class, but I really don't. I did some homework and sat for awhile and tried to come up with the best possible way for me to run all the components that I had. I would still like to get some sort of a switcher to completely bypass the...