Recent content by OlBoyMikeRyan

Channel 1 and 2 are totally fine. Channel 3 sounds like I'm getting 1% volume. I can very barely hear it working and if i crank the amp to ungodly volumes I can hear it. But obviously that's not ideal. Any ideas on what gives? This is a 90w combo. I have zero electrician skills and am not...

Hey guys. Just wondering if anyone is using this pedal from 29 pedals. It sounds amazing as a first in line buffer, but I've noticed that it causes my drive pedals to clip the overall signal. I spoke to the owner who told me it's definitely not supposed to do this. I'm wondering if something...

Thanks guys, I appreciate it. Using this amp is always a learning experience.

Hey Dom, I'm trying to understand this all. So the fx loop is a line signal and not a guitar/instrument signal? Aren't most modulation and time based effects made to be placed in the loop? How can I ensure there isn't an impedance mismatch?

Ah, that did it! It was the individual channel master being too loud! You guys are the best. I turned the channel 1 master down to about 9 o'clock and compensated for the loss of volume by turning up the general output knob and we're all clear. The Euna, for those who may have been curious...

Oh this part is interesting. When I bypass the loop (via back toggle switch) there is a MASSIVE volume increase. To the point where it's painful to the ear. This is interesting and strange to me because I always have the amp's overall output set incredibly low.

Wait, but isn't the FX loop made for those types of pedals? For reference, the EUNA is in front of the amp and the GFI synesthesia is in the loop. Those are the only two who are "clipping" because of the hot signal. Everything else sounds fine.

thanks guys! I actually tried dialing down the send level on the back of the amp. It seemed to help A LITTLE but not enough. @rarebitusa that's a little confusing. What is the processor? Just the system the mark V uses? I'm a bit confused. Remove both cables simultaneously and look for what...

Hey guys, I've got a Mark V 90w combo that I use predominantly on channel 1, switching between 'fat" and "tweed" setting. I've lately noticed an issue with a few of my pedals, namely the 29 Pedals Euna and the GFI Synesthesia. It seems that the signal from the Mark V is too hot somehow and is...

hey guys, this has happened a few times before and resolved itself but I can't for the life of me remember how. The issue is that suddenly the FX loop doesn't work. I haven't had a functional footswitch for a while now, but when I switch the settings in the back (my Mark V is the 90w combo) for...

Hey guys! I almost exclusively play this amp on channel 1's "tweed" setting. When I need more gain, I hit it with a Boss SD-1. I'm pretty happy with the sound it produces, but I've recently started feeling like it's a huge waste to leave channels 2 and 3 unused. The studio I practice at has...

Hmmm, that seems a little more difficult than I'd anticipated. Is it possible to just buy a new solder-less speaker cable and attach it that way? For example, the cable would have the 8ohm 1/4" plug on one end, and a solderless connection that I could attach to my new speaker?

Hey guys, I bought a replacement speaker for my Mark V combo. I had read that these amps used solder-less connections, but when I popped it open, I couldn't work the speaker connection off the way I'd seen in videos. I'm assuming it's soldered then? I have a soldering gun and solder but I...

Apologies if this has been asked before. I looked around briefly but didn't see a thread on it. I'm an extremely satisfied new owner of a mark V combo. I love so many different modes. My only issue is, is there a way to switch modes within channels without having to stop and flip the switch...