Recent content by domct203

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. domct203

    Shout out: EM Custom Midi Amp Controllers

    I use these on my Roadsters and Nomad. Works flawlessly and does not require an external power supply.
  2. domct203

    raw Head cab staining ?

    Stain is just a coloring, you will still need a top coat to protect the finish, polyurethane is the most common, available as a gloss, semi-gloss, or satin finish, and requires fine sanding (I use 0000 steel wool) between coats. I recommend you go and research wood finishing and furniture...
  3. domct203

    Mesa Triple Rec Issue

    Here’s some basics:
  4. domct203

    Mesa Boogie Dual Rectifier Roadster

    Do you get sound from the speakers if you hard bypass the FX loop? I’m not talking about foot switching the loop off, I’m talking about the hard bypass switch on the back of the amp. Hard bypass will remove V5 from the circuit. I also recommend checking the cathode follower tubes (V3 & V5) and...
  5. domct203

    Considering a Mesa Mark II A - Need Advice from the experts

    That appears to be his ‘59 LP/Tweed Deluxe rig which has been his staple for many years. https://www.guitarworld.com/features/don-felder-eagles-dear-guitar-2013
  6. domct203

    Using DI with mesa boogie mkv 25 requires a lot of volume to get signal to PA

    Where are you getting the DI signal from?
  7. domct203

    New to the Boogie Board

    Welcome to the forum.
  8. domct203

    Setting for dual rectifier fx loop

    Welcome to the forum. Loop on means just that, the FX Loop is always on regardless of amp channel. CH1 has the FX Loop on for CH1 only. The FX Loop will be off in the other channels. CH2 works the same as above, but the FX Loop is on on for CH2 CH3 follows above logic. FTSW means the FX...
  9. domct203

    Dual Rectifier Rev G drops volume after a while

    What tubes are you using in the preamp, specifically V3? Are they Mesa branded? JJ’s? Tung-Sol reissue? Mullard reissue? Russian tubes, especially New Sensor Corp brands (Sovtek, Electro-Harmonix, Mullard, Tung-Sol) can’t handle the voltages in the cathode follower (V3) and can cause volume...
  10. domct203

    Hello, glad to join this community!

    Welcome to the forum.
  11. domct203

    New to board

    Welcome to the forum.
  12. domct203

    Hello everyone

    Welcome to the forum! Dom
  13. domct203

    Question about impedance matching

    If you put the cabs in series you’ll have a 12 ohm load that you can safely run from the 8 ohm tap. You can easily build a series box with three jacks and a pedal enclosure. Dom
  14. domct203

    Randall Smith and Mesa Boogie Parting Ways??

    The whole ‘Randall was fired’ statement is nothing but click bait, and quite disrespectful IMO. The reason Mesa was sold is so Randall could retire. It’s time for him to enjoy the fruits of his labor and I wish him well. Dom
Back
Top