Audiokill
Well-known member
I have two 16 ohm cabs that I'd like to run into my C+ as a full stack. There is only one 8 ohm jack and two 4 ohm jacks on the amp, so running two 16 ohm cabs is not quite compatible - doable but not ideal. What I need to make this work is two 8 ohm jacks on the amp.
Now, looking at the inside of the amp, the first 4 ohm jack is wired in parallel to the second 4 ohm jack (the second 4 ohm jack is the one directly wired to the rest of the amp). The first 4 ohm jack only has the one lead wire connected to it, conjoining it to the second jack. If I were to disconnect that lead wire between the two 4 ohm jacks, then solder a wire between the first 4 ohm jack and the 8 ohm jack, would I then have two 8 ohm jacks?
Now, looking at the inside of the amp, the first 4 ohm jack is wired in parallel to the second 4 ohm jack (the second 4 ohm jack is the one directly wired to the rest of the amp). The first 4 ohm jack only has the one lead wire connected to it, conjoining it to the second jack. If I were to disconnect that lead wire between the two 4 ohm jacks, then solder a wire between the first 4 ohm jack and the 8 ohm jack, would I then have two 8 ohm jacks?