when i have my reverb on the lead channel or 2nd channel it just makes a high pitch noise and you cant here the reverb and it just destroys the sound, but it works on the clean channel fine? could this effect my normal lead sound when the reverb is still on zero? and when i kick my effects loop on it raises the volume and takes some of my distortion out even when know effects are on? could this be a tube problem?thanks
reverb problem on mark 4 help
- Thread starter Mark4
- Start date
Help Support The Boogie Board:
NoGlassNoClass
Well-known member
Try swapping out the preamp tube for the reverb. Think it is V4 or V5, but look in the manual to be sure.
NoGlassNoClass
Well-known member
Just checked manual...V3b is reverb send, V4b is return. Most likely your prob is a microphonic tube in one of these locations.
so probably get some new preamp tubes? so will that crappy tube effect my distortion sound because i know your supposed to be able to get bad sounds out of these but when my single rectifier sounds better i dont know what to say? thanks what do you think about the effects loop thing? because when i got it from the guitar store they ordered it from another one of there stores that had one in stock and lets say it didn't get packed to well box> amp> not alot of popcorn? thanks for your help
NoGlassNoClass
Well-known member
Mark4 said:
If its a new amp, the store should give you new tubes under Mesa's warranty. Even used, if it was damaged in shipping the store should take care of you anyway.
If you want to try something a little different, check out the hi-gain front end kit at www.eurotubes.com FWIW sounds excellent in a triple-rec. Havent tried them in MarkIV yet but next retube...
the loop thing probably also tube-related. Try taking the preamp tubes out and putting them back in...maybe just loose in their sockets?
