Problem switching a Roadster with Mini Amp Gizmo

[harem_theater]

Hey guys.

Just purchased an RJM Mini Amp Gizmo to run with my roadster head and i have this problem where i switch between the four channels (after setting up the first four switches to momentary of course) and the "loop" light on my amp comes on but not as bright as if i had turned it on with the supplied footswitch. other buttons don't seem to function like i would expect either (they don't light up the corresponding functions as explained in the manual). And yes i'm using the right cable before anyone hits me with that.

Also, when i have my channel selector on the back of the amp set to ch1, i get this crazy flickering relay noise coming from the amp when i turn ch1's FX loop on, but it goes away when i turn it off....


Any guesses that aren't "take it back for a new one" would kick ass because i'm in australia.

thanks heaps everyone

Matt

 

[joe web]

set the Amp Gizmo to latching! not momentary - after that make sure you set it up for 4 channel amps (so only one funktionswitch of funktion 1-4 can be active)
i´m using the RG-16 and it works perfect.
set the selector on the amp to "footswitch" not to any channel!
set the main loop on/off switch to "on". on each switch per channel set loop to "off", so you can switch it in with the amp gizmo.
if you have the small toggel switches on the channels set to "on" for the loop, you can´t turn it off!
but LATCHING is the way to go!

 

[harem_theater]

BAHAHAHAHAHAHAHA Nevermind. I'm tired and had the cable around the wrong way. Works perfect now.
Thanks, folks