Last night at practice my Roadster did something very strange....
All of a sudden, when I would switch channels, there was a delay occuring between the channel switch.
I switched from ch4 to like ch1 and it would cut out for a second and then fade back up!
It's never done this before.
It was like there was a gate between channels. It did this on all channels.
I turned the amp off for a few minutes and restarted and it went away.
I checked the footswitch cable and it seemed tight but maybe just a hair loose in the jack.
Would this cause the amp to do this if the cable was even a tiny bit loose? If so, I need to secure it better on the floor.
I bypassed all FX loop and FX pedals also.
If not.........I hope a relay is not overheating and causing this.
Tell me it's not the switching relay.........
Thanks.
Mesa Roadster/EL34's
Digitech RP-1000
Line6 DL4
OCD
4x12 1960-A
All of a sudden, when I would switch channels, there was a delay occuring between the channel switch.
I switched from ch4 to like ch1 and it would cut out for a second and then fade back up!
It's never done this before.
It was like there was a gate between channels. It did this on all channels.
I turned the amp off for a few minutes and restarted and it went away.
I checked the footswitch cable and it seemed tight but maybe just a hair loose in the jack.
Would this cause the amp to do this if the cable was even a tiny bit loose? If so, I need to secure it better on the floor.
I bypassed all FX loop and FX pedals also.
If not.........I hope a relay is not overheating and causing this.
Tell me it's not the switching relay.........
Thanks.
Mesa Roadster/EL34's
Digitech RP-1000
Line6 DL4
OCD
4x12 1960-A
