I have managed to sausage finger the push/pull knob of my lovely Mark IV Mesa Boogie. (well the boot of my car did) & have sourced the replacement pot from Mesa themselves.
Is this the kind of repair that I can do simply at home? It looks like there are two points to solder. If so any tips on dis-assembling?
I'm not mechanically too bad, and I'd like to think I know when to stop but is this straightforward? I'm not great at soldering but with some patience and my reading glasses on I can probably do this.
Thanks
Jol
Is this the kind of repair that I can do simply at home? It looks like there are two points to solder. If so any tips on dis-assembling?
I'm not mechanically too bad, and I'd like to think I know when to stop but is this straightforward? I'm not great at soldering but with some patience and my reading glasses on I can probably do this.
Thanks
Jol