I have a Lonestar Special which has just started to make noises when the standby is switched out to start playing.
It is like waves of white noise ( like the sea rolling in ) and some squealing too. Then after about 5 to 10 minutes it is all back to normal and plays absolutely fine.
It is not channel dependent, and switching the FX loop in/out makes no difference. No controls affect the noise, reverb included. This only happens coming out of standby.
I changed all the tubes and the problem persists.
Any ideas ?
Thanks
Joe
It is like waves of white noise ( like the sea rolling in ) and some squealing too. Then after about 5 to 10 minutes it is all back to normal and plays absolutely fine.
It is not channel dependent, and switching the FX loop in/out makes no difference. No controls affect the noise, reverb included. This only happens coming out of standby.
I changed all the tubes and the problem persists.
Any ideas ?
Thanks
Joe