What do you guys think is best the Rocktron Hush, Isp decimatorprorackG, Samson S-Com, Or Behringer Quad Gate. I have the ISP but i have 2 other guitar players not including the bassist. I am running a Mesa Triaxis and 2/90 the singer Is using a Genz Benz El Diablo and the third is Using a madison Divinity 2 lots of gain distortion lots of noise. Any suggestions the isp is expensive but i don't know about the quality of the others I need some input guys. :?: :?
Help Please 3 Guitar Players Rack Noise Gates??
- Thread starter BrentSSL
- Start date
Help Support The Boogie Board:
elvis
Well-known member
They will all help. One is probably the best, but do you need the best, or just better?
They should try an NS-2 for starters. That might get them to "good enough".
They should try an NS-2 for starters. That might get them to "good enough".
elvis
Well-known member
Put the NS2 in a rack or on top of the amp. :roll:
My point was that you seem to have a budget issue, so it may be helpful to better define the required outcome (how much noise reduction is really required), and how you might be creative in solving it for less $$.
Otherwise, get more Decimators and be done with it.
My point was that you seem to have a budget issue, so it may be helpful to better define the required outcome (how much noise reduction is really required), and how you might be creative in solving it for less $$.
Otherwise, get more Decimators and be done with it.
Screamindv
Active member
- Joined
- Dec 4, 2008
- Messages
- 42
- Reaction score
- 0
OK. I go from my guitar into CH 1 of my Decimator. Out Ch 1 of Decimator into input of Triaxis. This tracks noise coming from my guitar. I then go out of triaxis loop to in of Ch 2 on Decimator. I go from the out of CH 2 decimator into a TC Electronics G System. If you use no effects, you would go into the triaxix returns. I also have a gate on mt G System that is active and I have a Behringer Multigate Pro. Triaxis Out Left and Right into BBE in A and B. BBE Left and Right Out to in of Multigate channels 1 and 2. Out of Multigate to in of Mesa 2:90. I also use channels 3 and 4 on multigate on outputs of my Rectifier Recording. That is to tighten up the sound for palm muting. I also use 2 channels of ebtec hum eliminator in various stages in my rack.my rig goes from dead silence to ear splitting. The main reason for having so many stages of noise reduction is so I have total silence on my high gain settings and yet I don't lose any delays on my clean settings.
