plumptone
Well-known member
DC 3 Question. I drive the front end with Wah>DynaComp>Phase90. I then run a separate effects chain through the loop that goes like this: Delay (pedal)>rack tuner>rack chorus>rack verb (all switchable remotely with latch pedals.
Having a very hard time getting the signal to remain constant and quiet when I engage the effects that run through the loop; i.e., there's a significant jump in volume. I run the effects mix from the back of the amp at 100% and then tailor the effects' output through the rack units. If I run it with the effect at 100% wet, and trim the mix down, the effects are barely noticeable. Any suggestions? Coud there be an impedence mis-match between the rack gear and the delay pedal that's causing this?
Having a very hard time getting the signal to remain constant and quiet when I engage the effects that run through the loop; i.e., there's a significant jump in volume. I run the effects mix from the back of the amp at 100% and then tailor the effects' output through the rack units. If I run it with the effect at 100% wet, and trim the mix down, the effects are barely noticeable. Any suggestions? Coud there be an impedence mis-match between the rack gear and the delay pedal that's causing this?
