Recent content by titan7

So I finally broke down and picked up a Boss BCB60 pedal board to place my tuner, Noise Suppressor, Super Chorus, And Fulltone OCD. I hooked everything up the signal goes like this: Guitar>Boss pedal box input>tuner>Noise Suppressor>Chorus>OCD> DR input. I am not using the fx loop? Should I...

SC-250

great price, throw some new tubes in and see what you have. You will love the amp they just rock!!!

I have a DR with the metal diamond plate, I just noticed the Mesa Logo plate is crooked? Looks like it was installed with the right side about 1/16" lower that the left. I know it's not the end of the world but are these replaceable? I guess I can call Mesa but I thought I would check here...

Get the AV, I have 1960 Vintage straight cab with V30, a 1960 Vintage slant cabwith 2 v30 on the bottom and two G75? on top. The 1960 straight cab sounds better but my Mesa recto 4x12 slant cab just kills them both. You can pick up a used retro cab for about 500-550. I got my for $550.

Absolutely correct in my opinion. I have 2 marshall 1960 vintage cabs with v30s, marshall branded v30s. I though how much difference can the cab make, I picked up a Mesa Retro slant 4x12, WOW, I wish I did this sooner, what a difference.

Sounds like a Oversized Retro cab. You can tell the difference, the marshall 1960s are 30" tall the Retros are just about 33" (measured without casters).

Thanks!!! BTW, those Fulltone OCD pedals are really nice, great range of tones and the build quality it top notch!

So I get my new Fulltone OCD pedal today, I have not used pedals is SO long. I grab a short 3 ft cable and my normal 10 footer. plug in, turn of stby, I get a wierd sound, almost feedback (it was very low volume). I put the amp in stby again and look what's going on, Oh that 3 footer, that was...

Thanks, I will give the Fulltone OCD a shot, do you suggest running it on the front end or via the Fx loop? thanks!

Okay, progress, both on sound quality and blowing my freaking ear drums out :lol: Switched to Diode rectifier and Bold power mode. Also followed some of the suggestions here and in the manual, much, much closer to the tone I was looking for. will running the gain at 2:30 hurt anything...

Thanks, I think that may be the issue, I heard these were touchy and a bit harder to dial in. Does the rectifier mode do anything?

So yesterday I picked up a mesa cab that's looks almost new, 2 very small while scuffs on the bottom left side of the tolex, about 1/4x 1/8", a tiny dab of black paint, all gone. The scuffs did not mess up the tolex but the white rub marks got on the tolex and were not coming off, the paint just...

Sorry about that! I have the rectifier on Vacuum tubes, Power on Spongy, I seem to like Channel 2 Modern. I have the following settings. Output: 11 oclock Presence: 2 oclock Master 10:30 Gain: 12 noon Bass: 3 oclock Mid: 9 oclock Treb: 3 oclock How bad is this? Using a MB Rect Slant 4x12...

I am pretty new to the Mesa Dual Rec. I have been messing around with it a bit and can't seem to get a good thick, saturated, palm mutted rythem sound. It's sounds a bit sterile, with no thick chunk to it. I figure it's the settings? Play with a PRS SC250 and Les Pauls. Any tips...