Recent content by racer*x*

actually he didnt know he was going this route in the begining! wide cabs are available.

man people could argue this with the chickens and the eggs sitting on top of the amp and still no solution. you guys are leaving out tons of variables in this whole equation. guitars, cabs , technique, the users ability to understand mesa gain stages in different amps, the room its tested in ...

new pics are up of jasons markll thiele at www.boogafunkcabs.net . also for those who have asked , weve got an 18.5 width with the same ev spec cab. we simply added .500 to each side. adds about 2 pounds to the already light cab! the sides will be 1.25 from the front view/ with the .750 top and...

i play les pauls exclusively, although i do own strats , which im currently selling, the les paul is just undeniably a better sounding axe for me. although i play the dc pauls in arch top with aaa tops. i have one with rio grandes and the other burstbuckers. they are 24 fret and i wouldnt trade...

M A P minimum advertised price. we cant advertise them cheaper ! bye bye dealership if you get caught. we can however drop the price of a cab loaded. but even dealer pricing is quite expensive. list price on the evm12l is 249, map is 195, dealer is about the same difference between those two...

to answer two questions , the arauco is not cheap like luan, it is actually as expensive as birch. the reason we use it is because the layers are thicker, there are no voids in the material , and it is consistent density throughout. Good eye on the finish! this one is glossy. we have two ways...

im pretty sure my mark 3 is a simulclass!

Hmmmm.... good idea , except you might run into a problem with the speaker being behind blinders. your looking at about 4-5 inches recession, i think that might start to make the speaker directional. youd have to look at some dispersion patterns. how about this, hard styro foam! its super light...

all great thoughts! but in my case where i play this one gig that has 35 ft ceilings and the stage is 5 foot off the ground it gets tricky. you dont wanna beam people in the face but you dont wanna shoot the guitar over their heads per se either. mixing is a tricky thing. ultimately a guitarists...

i suspect shipping would be determined on how fast you want it. there is a guy whoes built one on here as well that looks nice. you can see my post on my thoughts of the widebody in the other thread.i can build whatever is desired, however i dont wanna tie up bandwidth discussing it here as im...

just outa curiousity what diminsions did you use the ev spec or boogie spec? i noticed two different theories on our bracing, one suggested a poor mans joint and the other suggested braces break speaker pattern waveform distribution. IMHO boogie neglected the braceing because of a cost and time...

Looks great! im glad someone else has testified about the time and labor intensity of these projects. yours turned out awesome and your skills show. ill comment more later on the different sizes and one very important factor that boogie left out. Damping makes all the difference in the world!

Oh and BTW " that funky pine" is actually cabinet grade 7 ply sanded. also every void has been filled in between the layers to insure consistency. That stuff actually is about the same price as birch. about 40 bucks a sheet. http://www.coxlumber.com/arauco.html check out the specs on this...

Hey lester! this is Scottie, other half of Boogafunk cabs. I just registered here but ive been lurking for years. We are on the south end of Whitesburg near the Ol Gin. Come by any time, we are always there late! BTW. did you by any chance used to talk on the cb radio, if so i think ive met you...