On the 3 channel dual & triple owner' manual said:
NOTE: On the Dual Solo Head it is possible to run two 6L6 or EL34 tubes pulling the two center tubes, leaving far left and far right tubes intact. This procedure reduces the power by approximately 50%. Remove one of the Rectifier tubes if you are using the TUBE RECTIFIER setting to assure a correct match.
So, doesn't note about ½ speaker out put need, example 16.Ohm speaker in to 8.Ohm jack rear.
How to speaker connect right?
NOTE: On the Dual Solo Head it is possible to run two 6L6 or EL34 tubes pulling the two center tubes, leaving far left and far right tubes intact. This procedure reduces the power by approximately 50%. Remove one of the Rectifier tubes if you are using the TUBE RECTIFIER setting to assure a correct match.
So, doesn't note about ½ speaker out put need, example 16.Ohm speaker in to 8.Ohm jack rear.
How to speaker connect right?
