RocketRick
Well-known member
- Joined
- Feb 16, 2009
- Messages
- 123
- Reaction score
- 0
Opps.....It broke off and I need to replace it.
Possibilities:
1. Take the existing one out and epoxy the knob back on to the switch shaft (Prob want work), or
2. Contact Mesa , get a new one and install it.
Not sure I trust any techs here in ANC to fix it.
I did the solder mod to accept diff tubes earlier so stink I cld do it.. I hope.
Any ideas or suggestions appreciated.
Rick
Possibilities:
1. Take the existing one out and epoxy the knob back on to the switch shaft (Prob want work), or
2. Contact Mesa , get a new one and install it.
Not sure I trust any techs here in ANC to fix it.
I did the solder mod to accept diff tubes earlier so stink I cld do it.. I hope.
Any ideas or suggestions appreciated.
Rick
