Hello, noob just want to introduce myself and ask a question

[sean106ESP]

Hi guys first post and just wanna say hi as I am sure I will be posting a lot here. Used to have a lot of recto's and then went the Diezel route, but for my new band rack I am running a Triaxis and a 20/20...and back to the boogies. So just wanted to say hi and ask some questions.

With the Triaxis, and 20/20 would you run the G-Force between the 2 or just right into the preamp? I had it right into my Diezel Vh4Spre amp and had phenomenal results.

Also I am using Ground control Pro to control G-Force and want to control the Triaxis. Is there anything special I need to do other than just get a 7 pin midi cable to a 5 pin input to the GCP?

Also can some one direct me to a link with some settings? She sure is a tweaker, but man from what I heard so far, it sounds sick!

 

[Bobby Marshall]

Also can some one direct me to a link with some settings? She sure is a tweaker, but man from what I heard so far, it sounds sick!

Welcome.

Here is a link to the Triaxis settings on the Boogie Board.

http://www.grailtone.com/tone-settings/mesa-boogie/view-triaxis-settings.html

I don't own a TA (triaxis) or a G Force but I thought it was very similar to the G System that I have wanted for awhile. You would plug your guitar into the G Force first for the effect section that is before the preamp, then into the preamp, out of the preamp and back into the G Force for the post preamp effects, then into the power amp section.

Hope this leads you to where you want to go.

Good luck.

Bobby

 

[sean106ESP]

Thanks a lot man, will try em out tomorrow. I need that damn 7 pin cable I ordered a week ago

:evil: :evil:

 

[ytse_jam]

welcome to the board sean!

You would plug your guitar into the G Force first for the effect section that is before the preamp, then into the preamp, out of the preamp and back into the G Force for the post preamp effects, then into the power amp section.

I've got no experience with those TC electronic products.... I'm assuming you're using the two channels originally meant for stereo separately right?

 

[tramp]

Don't put the g-force in the loop of the tri, take the two outs of the tri into the G-force and then into the 20/20...by far the best and is the exact same rig as I use

regards

 

[sean106ESP]

Thanks guys! It looks like wiring diagram number 3 in the manual looks like my best bet.

However I have not read what the "switches" do on the TZ as in the diagram of manual on page 16

goes to a 2:90 and I just have 2 inputs on the 20/20. I guess I should just take the switches at of the equation? Thanks again fella!

Sean


Also any advice on rack spacing....meaning should the pre and power be away from each other as they heat up etc?

Sorry for the big pic