Mesa/Kramer
Member
I have been having an issue with the effects loop of my MK III for a while now.
Was wondering if anyone had any insight on this.
When I run "anything" into the loop of my Mk III, the amp will sound normal for a few minuets, then the volume level of the amp will drop out to almost nothing.
30 seconds or so later, the volume will come up some, but sound like a blanket is over the amp. It will continue to get a little louder then will come back all the way and sound normal for a few minuets, then repeat, all over again.
I can wiggle the cords going into the loop and get it to stop momentarily (Its not the cords)
(This issue does not occur if nothing is in the loop.)
I have bought all new cords, have tried many different items in the loop, and it is all the same.
I run the same exact set up effects wise into my DSL 50 and never any issues.
Before I take it to a tech, just wondering if there is anything I can try?
Was wondering if anyone had any insight on this.
When I run "anything" into the loop of my Mk III, the amp will sound normal for a few minuets, then the volume level of the amp will drop out to almost nothing.
30 seconds or so later, the volume will come up some, but sound like a blanket is over the amp. It will continue to get a little louder then will come back all the way and sound normal for a few minuets, then repeat, all over again.
I can wiggle the cords going into the loop and get it to stop momentarily (Its not the cords)
(This issue does not occur if nothing is in the loop.)
I have bought all new cords, have tried many different items in the loop, and it is all the same.
I run the same exact set up effects wise into my DSL 50 and never any issues.
Before I take it to a tech, just wondering if there is anything I can try?
