daisy chains. and ohm loads

[MetalMofo]

k with my mesa boogie mark 3.

i got two 4 ohm and 1 8 ohm input obviously.

now i want to daisy chain from one of the 4 ohm input into an 8 ohm cab, then from that 8 ohm cab run it to another 8 ohm cab. then run another 8 ohm cab into the 8 ohm input?

would this work? i think it will.

 

[MetalMofo]

nvm nvm...i got confirmation on a different forum saying it will not work.

k...well i would run one of my traynor 8ohm cabs into one of my 4ohm load inputs, and my 2x12 into the other 4ohm input right?

both cabs are 8ohms.

 

[Fxrs]

nvm nvm...i got confirmation on a different forum saying it will not work.

k...well i would run one of my traynor 8ohm cabs into one of my 4ohm load inputs, and my 2x12 into the other 4ohm input right?

both cabs are 8ohms.

correct.