I just posted a comparison of my Electra Dyne, recorded with a Sennheiser e609 and the new CabClone. You can check it out here if you're interested: https://www.youtube.com/watch?v=2Ir_MoZIGXM&index=1&list=UUFpi3GKiSjreuMHrJRajUgA.
[audio] Electra Dyne Vintage High Gain->CabClone
- Thread starter dlpasco
- Start date
Help Support The Boogie Board:
Great tones there bud! I've been intrigued by the cabclone as well. Imo, the Electra Dyne sounds way better than the Mark III. Comparing the mic vs the cab clone was difficult because the cab clone' levels were quite a bit higher, and as I'm sure you know, when comparing we perceive louder as sounding better. Would it be possible for you to remix the track and try equal out the levels (normalize)? By the way, it sounded awesome and great playing too!
Birdy said:
I haven't done any low-gain samples yet, but I'll try and get to it this week.
The headphones sound great. I usually only use them if I walk the cab clone over to an amp in a different location than my DAW. If I'm close enough to the computer I plugin into my microphone interface (Apogee One or a Sternberg CI 1) and just monitor the XLR input instead of using the CabClone's headphone jack. Better for mixing.
Update: I've added the Mark III, using the Customized Marshall settings to the mix https://www.youtube.com/watch?v=rWgOWrTg400&list=UUFpi3GKiSjreuMHrJRajUgA
Probably not going to get to any low gain recordings for a day or two, but I intend to do them.
Probably not going to get to any low gain recordings for a day or two, but I intend to do them.
