Search results

I used the FX return level on my Line 6 HX FX to reduce the volume. -3db wasn't enough and -6db is to much. I don't remember this being an issue before I retubed it. I've had mine more than 8yrs and retubed it last summer after it blew a fuse. Might pull it apart and see if there's any visible...

So with the loop engaged and anything in the loop even just looping in and out with a cable my loop is 5-6db louder. I have the dial at unity on the back. Does anyone else have this issue? It makes it harder to play at reasonable levels. I can use my HX FX pedal to back it down, but would...

thanks you so much i'm a little ocd sometimes.

So along with my master volume not muting output at zero, when I mute my m13 in the fx loop it's not muting the amp. Yes fx loop is turned on... Is this normal?

i tried the other amp here at home and it doing the same thing.

Had the replacement amp 2 weeks and played it maybe 3 times. Haven't even sent the old one back yet. Just going to drive to Sweetwater tomorrow and deal with them directly. They tried fixing my first amp 3 or 4 times before I asked for a replacement and wait times are ridiculous. The first Mesa...

Thanks that's what I thought was supposed to happen.

Could anyone check with their amp? Then I can fall asleep peacefully.

I mean not faint but actually could practice by myself volume level.

I have my Master all the way down but i'm still getting some sound of out my speaker. This is a replacement amp because my first one was a lemon. I can't remember if this is normal but 99% that it's not. It even did it on the clean channel, channel master about 9 o'clock.

It's at Sweetwater being "repaired" salesman said it was probably a tube but since they just retubed it they can replace a bad tube.

What type of voltage regulator did you buy? I know i can't use my amp at home till I find a solution. I'm looking for more of a technical perspective on the effect on what to look for to determine if perms an damage has been done to my amp.

So the a/c in my apartment 135vac apparently the reason my mark noisy as hell even on the clean channel. My question is what damage could or has this done? I already had to have the pretubes replaced before it was 6months old. Just found out today voltage was bad. I need good reasons to push my...

Turns out my wall voltage is at 135, loaner amp causing the same problem... Hope my amp not permanently damaged.

Thanks that's what i needed to know. i guess plugging in a guitar exaggerates it.

What is the normal level of hum or buzz from channel 1 not set to tweed? I haven't used the none tween modes of channel 1 until after my amp came back from repair. When my amp came back from repair, i'm getting a lot more hum than i'm used to from clean channels on amps and i'm getting a buzz...

If anyone tries one of the APC regulators i'd like to hear how well it works, they are very inexpensive.

How durable are you guys finding your mark V heads? I've had mine since june or july and its already i need of repair. The solo boost has an intermittent issue, i kick it on and it's acts like it's maxed out even if it's practically off. I can tinker with it and it works normal for a bit. The...

the 90W ratting is also rms not peak on the speaker.

Your pretty much asking for it weight wise if you buy a combo. #1 reason i don't buy them.