Search results

Stiletto and Recto

I purchased a Series II Rectoverb 1X123 combo last year. I came with a C90 that to my ears is dark and the amp is very 1 dimensional. I'm going to swap the C90 out for something different. Have yet to hook it up to the Recto 4X12 cab w/ V30's. That may help with speaker decision. Thanks for...

Older pic of LH- Stiletto Trident Stage 1 EL-34's atop 2 EVH 2x12 cabs with Celestion G12-H's, I like these speakers with the ST. RH-Mark 5 6L6's 90W atop Rectifier 4x12 with V30's. I run these stereo, best of both worlds IMO. Also, 1976 Fender Champ silver face, HiWatt 5 watt head w/ Orange...

I tend to live in channel 2 (all modes) with the MV 90w. I need to spend more time in channel 3 to get it to my tastes. Channel 1 is awesome as well. Still learning this beast, kind of fun I like !

I like the way my Stiletto Trident sounds through G12H's. Got balls.

reganjeremy. I'm using a Mesa Recto 4 X 12" with 4 V-30's. It's 10 years old and speakers are well worn in. I like it. I do use the effects loop with an EQ, EQ is off but loop is active. I'd like to try different speaker combo's when $ permit but for now I'm liking it. I also have an EVH 2x12...

Hi. I've recently purchased a new Mk5 90W head. Channel 1 and 2 are impressive, channel 3 not so much. So, the quest begins here in this thread.... I've read quite a bit of the content here but not all 50+ pages. I swapped in mesa 12at7's into V4 and V6 and a (SPX into V1 to try to help noise...

I've taken the long cap off a few times and you are right, mace, the locator nubs are wearing down :!: .

?? So you can grab it and not have to dis assemble anything else ?? My guess. Good luck getting the tube back in and the shield back on without removing the tank. I did it once, the very first time re seating all of the tubes. The second time I was dropping an SPAx7 into V1 and I couldn't get it...

Agreed. Blind assembly is a knuckle bleeder. I have left DNA in my head after the tube re seat. Dis assembling the reverb tank requires a low profile Phillips ratchet on the one screw, same side as V1. Learned that after struggling... Re assembling the reverb tank is also a PITA due to the...

Not sure how to crop this pic down a bit but here's the new setup. I've had the Stiletto and 4x12 since 2009. New MV 90W purchased last month. I split out stereo from a TC Nova Delay. Just getting used to how to balance the 2 out. Clean settings are working out the best so far. The Mark 5 is a...

As a Stiletto Trident Stage 1 for the last 10 years, I've finally stepped up and into a Mark 5 90W. She sits atop of a 4X12 Recto Cab and the Stiletto sits on a 2X12 G12H. I spent a good 2 hours Friday night dialing this MV in and I have to say AWESOME. Clean channel 1 is beautiful. Mark1 mode...

I have a Stage I Trident. I've never played through a Stage II, but from what I gather (here in this forum), the II is more like a modded JCM800 and the I is more like a modded Plexi ? This post is almost a year old..... :roll:

Just purchased a pair of Mesa EL-34's. Price is up to $65.00. Bought 2 sets of pairs back in early September and they were $59.00. Anyone have a clue ? Low supply ? More expensive source ? Economy doing better ? ? :cry:

sorry, I don't have an answer and I hope your problem is fixed. I just find it surprising that with 130 views of your post and not one response. I have a tube question in the Modern Amp area, 50 views and not one response. :roll:

Tons of traffic in here. Ended up replacing all pre amp tubes, did not fix the noise issue. Found another bad power amp tube, almost went into full meltdown mode :oops: , replaced 2 of the three pairs with matched duets . So far, so good.

I found 1 bad tube of a matched pair (outer pair) that was bad. I replaced it with a good el34 but it's not matched. This is only temporary, about 4 days. Will this be an issue ? Will be getting matched pair next week.

I am a proud owner of a Stiletto Trident, Stage 1. The late tube amp I owned before this one was a HiWatt Custom 100 (wish I had that thing back). Sorry for the late post, I don't get in here much.

Is that a blowup ring you put on a toilet seat for comfort if you have roids ? :oops: JK. Google it.

I have a recto 4X12 slant cab with V30's. Works fine with my Stiletto head that are known to be thin sounding in some modes. I EQ a lot of that brightness out and the oversized cab helps to beef up the bottom end. Oh yea, it's heavy! 8)