Search results

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    Tubes for TA-15

    Wow! $679. I didn't know they were available at that price. If I had the money... It's Top Boost/Tweed for me. I almost got an AC15 but Top Boost driving an Alnico Blue made me go for the TA-15. I use Top Boost about 80% of the time. I like to use pedals but it sounds great direct too. I'm...
  2. A

    High Gain/Fuzz pedal for TA-15

    I'm happy with the empress multidrive which had OD, distortion and fuzz running in parallel with adjustments for each. For me it works best after a Fulltone Fulldrive 2 (Fulldrive in comp cut mode and low gain). It works well at low volume and has very useful 3 band EQ with 3 selectable...
  3. A

    TA-15 safe mismatch

    Thank you very much. I resisted the temptation to try it again until I learned more. i'll order the Y cable today.
  4. A

    Tubes for TA-15

    hi shimmilou, I know preamp tubs can last a while, but I think my well used ones are suffering, so I couldn't really compare with the factory set when they were in their prime. I think the main thing about the Tung sol i liked was where breakup occurred in the top boost mode. I haven't been...
  5. A

    Tubes for TA-15

    The power tubes on my used TA-15 looked burned so I got a pair of Mesa. The sound was more lively and clear afterward. I didn't want to mess with biasing power tubes or risking not doing it and the Mesa replcement pair is not too expensive. For the preamp, I had Mullard reissue, Tung Sol, JJ...
  6. A

    What speakers for the TA?

    I got a used Jet City 1x12 and replaced the OK sounding Eminence with a Celestion Alnico Blue. Sounds great on the Vox channel as well as channel 2. Took a couple of months to break in at the low levels i play at. I picked up a used Blackstar HT110, intending to put in a better 10 inch, but...
  7. A

    TA-15 safe mismatch

    I have two 16 ohm cabinets which I connect individually to the 8 ohm output with no problem. I'd like to use both at the same time. I tried it for a few minutes with one connected to the 8 ohm out (like I usually do-this is listed as a safe mismatch in the manual) and the other connected to the...
Back
Top