Search results

I actually took the pot completely apart. The solder connections were clean, and aside from a little grease for turning the knob it was clean on the inside too. All 5 of the preamp tubes are 12AX7-A Russian made. Perhaps the problem is that the V3 is using that tube.

ok so i finally got the chassis off and took a look at the pot. Everything seems perfectly clean. I am quite sure it is one of the preamp tubes. So now my new question is, is there a specific type of preamp tube I have to use for the nomad 45? The tubes that were on there are Russian made...

Hey guys thanks again for the help. I've tried to remove the chassis by removing the 4 bolts from the top like the manual says to. However, it will not come out! The manual says that it should slide out like a shelf, but something is still holding it at the front. I tried removing the all...

Thanks for replying guys. It is the output (ALL channels) knob. While I don't have a brand new tube, I've take a few of them out and swapped them around, but it doesn't seem to make and changes. I will order two tubes - one of the bigger and one of the smaller ones though. Until then, any...

Hi, I'm new here and I'm just looking for a little help with getting my Nomad 45 2x12 up and running properly. Last week it road in the back of truck to a friends house for some practice. For some reason the Input knob or the tube that controls the input levels is having some issues. When...