Search results

The Boogie Board

Help Support The Boogie Board:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    Noise gate to remove hiss on clean channel, upgrade to plus?

    I have an Express 5:25+ head and it hisses as well. Rolling preamp tubes has helped, but it still has not gotten rid of all the hiss. I've been told it's the nature of the beast. My Tweaker 15 head and Orange Rocker are both dead quiet compared to the Express. That said, at band volume it's...
  2. A

    EL84 Redplate Questions

    I've owned a Studio 22+, DC2, and Express 5:25+ and only have redplated a tube 1 time when the screen resistor burned out. Mesa EL84 tubes last quite a while. 5 years on my Express 5:25+ so far. Al
  3. A

    Cab Clone

    Reduced to $180 Al
  4. A

    Cab Clone

    8 ohm Cab Clone, with original packing. $200 pp and shipped to lower 48 Al
  5. A

    .50 caliber plus help please

    No, as long as you're not pulling the chassis out you'll be fine. Just lay the amp down on it's front and work it that way. You might want to have a flashlight so you can better see the pin configuration. If memory serves, you will probably want to pull the power tubes out to get full access...
  6. A

    .50 caliber plus help please

    Absolutely. Preamp tubes do indeed wear out, and sounds like you have more than 12 years on them, as you don't know how long there were in there when you bought the amp in 2004. That amp should have some really nice loud clean tones in it. I've never found the reverb to be lacking in any of...
  7. A

    Mesa Boogie Studio Caliber DC-2 - Longevity

    I have one I've gigged with numerous times. Great grab-n-go combo. I've rolled tubes and replaced the stock speaker with a WGS ET-65. Very solid amp. I plan on keeping it for a long time! Al
  8. A

    "Normal" hum on Mesa 5:25+ Combo

    Ley me add my 2 cents here as well. I've got a 5:25+ that hisses a bit too much for me. Well above my other tube amp's hiss. Put a set of Doug's tubes in, and the hiss went down by about 40% or so. OK, good deal. Second gig out both channels start cutting in and out. Not good. Found a...
  9. A

    DC-2 three channel options

    I use clean channel for cleans, Mythical OD on clean for crunch, lead channel for leads. Great little combo! Al
  10. A

    Tone difference between channels

    Happy to be of service... :mrgreen: Al
  11. A

    Tone difference between channels

    :lol: I feel your pain.....I'll be 60 next birthday. Yes, the gain order is Clean, Blues, crunch, then burn. Each one has higher gain and louder volume at the same settings, in that order. As Texas said, I've also used Blues for clean and crunch for my solos in the past. That's the beauty...
  12. A

    Tone difference between channels

    Not trying to be a smart-alec, but have you read the manual? The Clean channel will be fuller and fatter. The Blues has a bit more gain and it is aimed at single note soloing. That's on page 3 and 4 of the manual. So yes, that's normal. I have a 5:25+ as well. After I spent the first...
  13. A

    Crunch has more gain than Blues on Express 5:25+

    Yep, i've done that as well...... Al
  14. A

    Are you using pedals with the amp for clean sounds?

    I use a Mythical OD and an Ethos OD in front. Gives me tons of options.... Al
  15. A

    Express 5:50 - NAD and footswitch issues

    Yes, you can get a single footswitch and plug into the back. I do that with my Express 5:25+ for the channel and the solo. Much smaller footswitch than the stock one. Al
  16. A

    red hot el84s DC3

    Try this; http://www.thegearpage.net/board/index.php?threads/changing-negative-grid-voltage-mesa-dc-3-fixed-bias-el84-amp.822840/ I do not have the schematic... Al
  17. A

    red hot el84s DC3

    You probably lost a grid resistor. Get thee to a repair guy..... BTW - these amps benefit from the mod that lowers the bias of the power tubes. My tech did it and the tubes now run much cooler. Al
  18. A

    Footswitch Question to All.

    Here it is: Al
  19. A

    Footswitch Question to All.

    I already built my own. Just 2 1/4" jacks into the solo and channel on the back of my Express 5:25+. Works like a champ. Al
  20. A

    Mesa Newbie here...

    I started with the EQ flat. Once I felt like I had dialed in the tone controls I then pulled the center slider down a few db, then boosted the low end up some. Sounded good to my ears. Now, I have the classic "V" shape, with the outside sliders almost to the top, and the center slider down 2...
Back
Top