Recent content by twostring

Actually no... I camp on channel 2/fat for most of the time with the Roadster. I use bold as well, since I can't get the cleans to sound right with spongy. For higher gain, I actually like channel 3/vintage with mid gain and higher master volume to get the power tubes chugging. I played on...

Bear in mind that my main sound is pretty much what you heard on the video. Straight up clean blues tone with a Strat on channel 2. I tend to run a Blues Driver and a duo of tube screamers to bump up the gain in stages when needed. I rarely branch out from channel 2 (I run channel 4 high gain...

Update...new power tubes went in, dog-strangling went out. Seems like the tubes were the fault. I opened her up and zipped through the channels at nearly room-shaking volume and there was no hint that there were going to be any problems. Tap test resulted in no noise as well. Thanks to all...

swapped tubes around today (inside pair to outside, outside pair to inside) and the noise is still present in 50 watt mode. Ray of hope...switching to spongy and getting my tap on resulted in noise only on one tube (in either 50 or 100 watt mode). Replacement tubes will be here soon, so we'll...

Will do as soon as I get home. I've ordered a replacement set as well...even if the tubes in the amp aren't bad, it seems like a good idea to have some tubes laying about to test.

I don't have any extras laying about. The tubes are the same that shipped with the amp from Mesa...I would guess that they are about 2 years old.

Certainly does. I'd still like to get a few more opinions, but you backed up what I was thinking (and certainly hoping for).

If you will be so kind... http://www.youtube.com/watch?v=WAMQ8y1PEeo Anyone have any ideas? I'll just paste what I've already outlined on the youtube posting. A quick video to demonstrate a noise issue I'm having with my amp. Depending on how certain notes resonate in the amp, I get this...

I understand ya... I went from a twin reverb with a 30+ pedal board to a Boss GT-8 with a Fender Hot Rod Deluxe, then to Roadster and now I'm back to an analog board (although with far fewer effects this go 'round). Even though I'm happy with my board, I re-arrange things and swap stuff all...

While I like the theory behind the pedalpad board, I hate the result. With a board that size, you should be able to stuff a crap-ton of gear on it. Instead, you have to position pedals so the cable slots are available. Given a Pedal Train or flat board of the same size, you could stuff so...

This is the full-tilt setup... If there is a situation where I'm worried about the foot controller or cable getting kicked about, I just break out the duct tape and tape it to the floor. I've thought about adding some latches or velcro to the PT-2 and the foot controller to lock the two...

I keep mine out in front of my loaded Pedal Train PT-2. It stows nicely with the board in the PT-2 gig bag (with a digitech whammy in the front pocket ta boot!). I could never really justify having the floor board mounted on my pedalboard. There are many situations where I just show up with...

Care to explain? I think I might be having that very same problem (no kidding...wild arcing sound at times. Have to switch the amp to standby to get it to stop).

no power tubes laying about. I guess I've been waiting for an excuse to pick up some KT77s.

Anyone?