Recent content by moshpit903

Hi, I just got back here and see this and its close,and I do see the V1 area and the resistors look the same as what I have here -the burned one. Since I have been here I have scraped,gouged out all the carbon on the pcb,and filled with Circuit Works CW2500 coating,and everything looks good,but...

Mesa Boogie told me today over the telephone that they don't have any pcb's for the Single Recto Solo V2 's anymore,and no boards for any variety of Single Recto,Single Recto Rectoverbs or Single Recto Tremoverbs,so if they can't get me the correct resistor value for where my 1 resistor burned...

Ok I took the main pcb out as much as needed to be able to flip it over to inspect area around V1 on the side where the power tubes fit into the socket(s) and luckily minimal scarring/burned..probably will be ok with it,just need 3 new resistors.. I am going to try to load a picture here of the...

1 hour ago I actually clicked on the clean channel and had about zero volume,even with the channels master volume and gain on as high as it can go,and turned the output control up high as well and then barely got any volume,so I powered down fully,unplugged the reverb pedal from the FX loop,and...

I am new here and was looking at the classified listings and saw the rule saying a member must have 10 post minimum to place an ad there,so I am wondering if it can be done here w/o trouble ? I am looking for the Black Diamond plate tread plate I believe its called,and looking to buy from...

I just got this amp head 1 week ago,and after pulling the chassis out to clean it and the headshell,and to inspect the pcb and its parts to see if I can spot any trouble areas and I am happy to report the electronics get a clean bill of health. I know the Ruby 6L6 GCMS power tubes are about 2...

As the title says Hi to all here. I have been playing or at least messing around with guitars and amps since 85' and have always wanted a Mesa Boogie amp..well I finally got one,a Single Rectifier Solo Head Version 2 and I love it. I obtained the amp through a trade and I know I am happy with...