Hi all-
IS it normal for the Lead Drive control to have a very weak effect under 5-6 when the Vol 1 gain isnt near max? IF I have the Vol 1 on say 5-6, the Lead Drive at less than 6 results in an anemic sound...Do I need a new preamp tube perhaps?
I've seen a bit of negativity expressed toward the reverb on these amps, and I think it is a little overblown to be honest. Though, I guess it does depend on what your application is.
My thoughts - for general tonal enhancements/thickening/etc. the reverb is perfectly fine. If you are doing...
I am an F-50 user...currently going back and forth on "upgrading" to a vintage Mark.
Couple reasons I reckon:
-The trend of amps over the past 5+ years is toward smaller, quieter amps that can sound good at home as well as on the gig. Power scaling and all that. Even though the F-50 isn't...
Hi all- Looking for some opinions from those who have experience with both the F-50 and the Mark IIb.
I have been gigging regularly with a stock F-50 combo for about two years. This is my first Mesa, but I have played several others in the past. I've always wanted a vintage Mark in...
Looking at the Ernie Ball Jr series...does it matter which model? I've read that for guitar, you generally want the "passive" version of this pedal, but then I understand that using the "active" version (which has a diff pot value) will allow for a smoother taper.
Would like to buy a single...
Hi - I have an F50 combo that I picked up used, with what I believe are the original tubes...amp is at least 5 years old. I use it frequently. Anyway, right now when I turn the amp on (after having it on standby) it hums (not a squeal or a hiss, but a very dull hum). But if I give the...