dr.indiflidual
Member
- Joined
- Jun 1, 2006
- Messages
- 7
- Reaction score
- 0
The 20/20 power amp manual says if you "do not want to listen to the live speaker outputs, connect a load resistor with a rating of at least 40 watts and with a 4 or 8 Ohm impedance rating" when using the slave output.
I understand why this is required, but what exactly should be used?
I've seen a couple of DIY load resistor articles on the net, but not much else.
Is there something I can buy that does what I need for this?
I've read about the THD Hot Plate, but this seems to be more of a 'soak' to turn down the volume of the cab. I think I want something much simpler (and cheaper).
Any ideas?
I understand why this is required, but what exactly should be used?
I've seen a couple of DIY load resistor articles on the net, but not much else.
Is there something I can buy that does what I need for this?
I've read about the THD Hot Plate, but this seems to be more of a 'soak' to turn down the volume of the cab. I think I want something much simpler (and cheaper).
Any ideas?