Recent content by mark1406

Thanks for the link. Regards Mark

Who sells RFT valves? Thanks for your assistance.

The Tonebender helps with gain and compression. If it’s possible try one out. I think you will either love it or hate it. So try before you buy. Alternatively you could try a compressor. Regards Mark

My personal opinion is that Clapton is using a Tonebender on this track. I say this as the Tonebender has that long sustain you need for this track. The Solo sounds like he turned it off. Regards Mark

Sorry to hear the scammer got your money. These people have no shame. I have been scammed on the price of a guitar. It wasn’t what he claimed it to be. Regards Mark

I started out thinking Boogie were used briefly and I saw a mention in Wiki and gear sites and he used them for 16 years. I typically, remember Keith using an Ampeg VT-40. I had one for a while and they do the Mick Taylor era quite well. I didn’t follow them after Tatoo You, so I wasn’t sure...

Keith didn’t use Boogie amps for very long. Wiki has Keith using them from 77 to 93. 16 years is a long time.

This is the actual circuit diagram of the “preamp” stages of the 295 dual power amp. The drawings on the internet leave out the presence control. I hope this is of assistance to people needing to repair a 295 amp. I was quite surprised by the 400v orange drop caps going short circuit. It’s...

Red - coldest Yellow Green Gray Blue White - hottest You will want the 6L6’s to run a bit hotter and the EL-34 to run a bit cooler from my limited experience. The limiting factor will be the EL-34’s. If you run them too hot you will have a very short valve life. The 6L6’s as far as I can...

Okay, the saga continues. The output valves seemed fine and the amp wasn’t blowing fuses anymore. I tried plugging a guitar in and I was getting nothing out. I decided to use the iPhone to pump a sine wave into the amp and I got a sound out of it. I thought signal level might be an issue, so I...

I tested the caps with my Peak cap tester and they measured good. They are quite an expensive item to replace if there is nothing wrong with them. I measured all the resistors on the output stage and they were good too. I was surprised as carbon comp resistors typically drift over time. I’m...

Hi Woodbutcher The fault ended up being the bridge rectifier two of the four diodes were short circuit. I was surprised that they were 1N4007’s as they have a 1A rating and most guitar amp use 1A, but in this amp there are two power amps. I replaced the 1N4007’s with 1N5408 which have a 3A...

A friend of my brother was going to throw out a Boogie 295 dual power amp. I was shocked to say the least. Apparently he didn’t want to sell it as he was told it would be unreliable in the future. I certainly hope this person wasn’t a technician. I have had a quick look at it and it appears...

Try searching this forum first there are Mark 1 schematic diagrams here. There is a long thread with the title, “Help with my 1978 Mark 1” Regards Mark

Thanks for taking time to show me the pictures of the fitted speaker. Regards Mark